Important Note:

*All the robots sent from September, 17th 2018 comes with the new version of OpenQbo V2.0 installed!

Learn what you should do when you set up your new Q.bo One robot for the first time with our tutorial ( pictures ).

• Register at our Forum to share ideas, make queries and discuss any issues with us and other backers. Registration of our forum can done at the following link: https://thecorpora.com/community/

• Open the box from the side that has the sticker “OPEN THIS END”  | Remove the Foam | Stand your robot on a cleared area | Connect the main Power Supply and turn on your robot.

Connect the main Power Supply and turn on your robot

Good Job!. Enjoy!

HOW-TO

• Setup OpenQbo V1.0 Distro [Deprecated]
• Setup OpenQbo V2.0 Distro
• Config Scratch Mode
• Config DialogFlow V1.0
• Enable Google Assistance

DOWNLOADS

• OpenQbo V1.0 Distro
• OpenQbo V2.0 Distro

• HOW-TO How do I install OpenQbo OS image onto an SD card?

Addendum

Q.Board One Connections

Note: John DeMita, thank you for your suggestion on how to make our Q.bo One Set-Up more efficient.